Canton Appliance Repair
Book a repairRepair record › GE washers
We've repaired 29 GE washers for this problem between April 2019 and October 2026. This is what was actually wrong, counted from our own job records.
Of the 29 GE washers we've repaired for "not spinning", the most common cause was: shift actuator failed (5 jobs, 17%), followed by transmission failed (4) and motor control board failed (3). The parts we replaced most often were mode shifter, drive belt, drive motor.
Seen once each: water inlet valve failed, tub bearings worn out, too much detergent used, motor pulley stripped, motor wiring broken, drain filter clogged, tub nut loose, load overloaded or unbalanced, drum support failed.
One repair can replace more than one part, so these add up to more than the number of jobs.
Most of these jobs showed no code at all; the customer just noticed the problem.
Replaced the inverter board and drive motor under warranty and verified full wash and spin.
Motor control board failed · model GFW550SSN5WW · October 2026Replaced shifter and belt and passed diagnostic tests.
Shift actuator failed · model GTW325ASW0WW · June 2026Replaced the oil-soaked belt and the motor and transmission pulleys.
Motor pulley stripped · model YTW4514SN0WS · November 2025Replaced drain pump.
Drain pump failed · model WBSR3140D5WW · November 2021Replaced the mode shifter and ran a cleaning cycle.
Shift actuator failed · model GTWN4250D1WS · August 2021Each job on this page is a completed service call from our own records. After every repair, the technician notes the complaint, what was found and what was replaced. We group jobs by brand, appliance and complaint, then count the causes. Customer names, addresses and prices are never published. Last updated November 2026.
Compiled by Canton Appliance Repair from our technicians' completed service calls in Stark County.
The full record by brand, appliance and town is on our repair record page.
Book online any time, or call or text (330) 915-7222.