Book a repair

Repair record › Whirlpool washers

Whirlpool washer not spinning: what we usually find

We've repaired 65 Whirlpool washers for this problem between March 2019 and October 2026. This is what was actually wrong, counted from our own job records.

Of the 65 Whirlpool washers we've repaired for "not spinning", the most common cause was: drive hub worn or stripped (14 jobs, 22%), followed by lid switch failed (7) and transmission failed (6). The parts we replaced most often were drive hub, lid switch, clutch.

22%drive hub worn or stripped
65repairs on record
82%fixed (53 of 65)
45different models

What was wrong

Drive hub worn or stripped14 · 22%
Lid switch failed7 · 11%
Transmission failed6 · 9%
Clutch worn or failed5 · 8%
Shift actuator failed5 · 8%
Drive shaft corroded or seized3 · 5%
Water inlet screen clogged2 · 3%
Main control board failed2 · 3%
Drive motor failed2 · 3%
No fault found2 · 3%
Motor coupling failed2 · 3%

Seen once each: loose part under tub, lid lock failed, water supply turned off, lid lock connection fault, transmission shaft splines worn, water inlet valve failed, drain pump failed, washer not level, drain hose siphoning, tub support broken, timer failed, pressure sensor hose damaged, tub bearings failed, tub pads worn, drain blocked by foreign object.

Parts we replaced most

One repair can replace more than one part, so these add up to more than the number of jobs.

Error codes we saw

Most of these jobs showed no code at all; the customer just noticed the problem.

How these calls ended

Recent repairs

Replaced main control board and ran test cycle.

Main control board failed · model WTW4957PW0 · October 2026

Replaced drive motor and start capacitor.

Drive motor failed · model LSR5132PQ0 · October 2026

Replaced main board and ran auto test.

Main control board failed · model WTW4957PW0 · August 2026

Replaced the clutch and motor coupler.

Clutch worn or failed · May 2026

Replaced hub and wash plate.

Drive hub worn or stripped · model WTW5000DW3 · December 2025

How we count

Each job on this page is a completed service call from our own records. After every repair, the technician notes the complaint, what was found and what was replaced. We group jobs by brand, appliance and complaint, then count the causes. Customer names, addresses and prices are never published. Last updated November 2026.

Compiled by Canton Appliance Repair from our technicians' completed service calls in Stark County.

More on Whirlpool washers

Related

The full record by brand, appliance and town is on our repair record page.

Having this problem?

Book online any time, or call or text (330) 915-7222.

Book a repair