Canton Appliance Repair
Book a repairRepair record › Maytag washers
We've repaired 19 Maytag washers for this problem between July 2019 and September 2026. This is what was actually wrong, counted from our own job records.
Of the 19 Maytag washers we've repaired for "noisy", the most common cause was: tub bearings worn out (4 jobs, 21%), followed by drive hub worn or stripped (3) and transmission bearings worn out (2). The parts we replaced most often were drive hub, transmission, bearing assembly.
Seen once each: loose center bolt, suspension rods worn out, bent bottom plate, loose splutch nut, no fault found, splutch assembly failed, wash tub corroded, wash tub loose on shaft.
One repair can replace more than one part, so these add up to more than the number of jobs.
Most of these jobs showed no code at all; the customer just noticed the problem.
Replaced the bearings.
Tub bearings worn out · model MVWB750YW0 · October 2021Replaced shift actuator and hub.
Drive hub worn or stripped · model MVWC465HW2 · August 2021Replaced the drive hub.
Drive hub worn or stripped · July 2021Replaced transmission belt and hub.
Drive hub worn or stripped · model MVWC655DW1 · June 2021Tightened center bolt and replaced small broken springs.
Loose center bolt · model MVWX700XW1 · April 2021Each job on this page is a completed service call from our own records. After every repair, the technician notes the complaint, what was found and what was replaced. We group jobs by brand, appliance and complaint, then count the causes. Customer names, addresses and prices are never published. Last updated November 2026.
Compiled by Canton Appliance Repair from our technicians' completed service calls in Stark County.
The full record by brand, appliance and town is on our repair record page.
Book online any time, or call or text (330) 915-7222.