Canton Appliance Repair
Book a repairRepair record › Maytag washers
We've repaired 28 Maytag washers for this problem between April 2019 and July 2026. This is what was actually wrong, counted from our own job records.
Of the 28 Maytag washers we've repaired for "not draining", the most common cause was: drain pump failed (11 jobs, 39%), followed by drain clogged by debris (5) and drive hub stripped (2). The parts we replaced most often were drain pump, water inlet valve screens, drive hub.
Seen once each: drain pump filter clogged, control board failed, pressure sensor hose broken, water inlet valve leaking, water supply turned off, shift actuator failed, transmission splines worn, washer needed calibration.
One repair can replace more than one part, so these add up to more than the number of jobs.
Most of these jobs showed no code at all; the customer just noticed the problem.
Replaced the pressure sensor hose and air dome.
Pressure sensor hose broken · model MHW6000XW2 · November 2021Replaced the stripped drive hub again and advised a transmission is needed.
Drive hub stripped · model MVWC415EW1 · October 2021Replaced the drain pump.
Drain pump failed · model MHWE450WW01 · October 2021Replaced drain pump and tub bearing kit.
Drain pump failed · model MVWB300WQ1 · June 2021Replaced the shift actuator, cleaned the inlet screens and calibrated.
Shift actuator failed · model MVWX700XL2 · March 2021Each job on this page is a completed service call from our own records. After every repair, the technician notes the complaint, what was found and what was replaced. We group jobs by brand, appliance and complaint, then count the causes. Customer names, addresses and prices are never published. Last updated November 2026.
Compiled by Canton Appliance Repair from our technicians' completed service calls in Stark County.
The full record by brand, appliance and town is on our repair record page.
Book online any time, or call or text (330) 915-7222.