Canton Appliance Repair
Book a repairRepair record › Maytag washers
We've repaired 42 Maytag washers for this problem between March 2019 and October 2026. This is what was actually wrong, counted from our own job records.
Of the 42 Maytag washers we've repaired for "not spinning", the most common cause was: drive hub stripped (16 jobs, 38%), followed by transmission failed (7) and shift actuator failed (4). The parts we replaced most often were drive hub, shift actuator, drive belt.
Seen once each: motor control board failed, broken motor wire, drain pump failed, no fault found, lid switch failed, water level pressure sensor failed, spin clutch assembly failed, drive belt failed.
One repair can replace more than one part, so these add up to more than the number of jobs.
Most of these jobs showed no code at all; the customer just noticed the problem.
Installed a new spin basket hub as a temporary repair.
Drive hub stripped · model MVWC415EW1 · August 2021Replaced the drive hub.
Drive hub stripped · model MVWC415EW1 · July 2021Replaced the basket hub.
Drive hub stripped · July 2021Replaced the hub.
Drive hub stripped · June 2021Installed new thrust bearing kit and motor tightener spring.
Thrust bearing worn out · May 2021Each job on this page is a completed service call from our own records. After every repair, the technician notes the complaint, what was found and what was replaced. We group jobs by brand, appliance and complaint, then count the causes. Customer names, addresses and prices are never published. Last updated November 2026.
Compiled by Canton Appliance Repair from our technicians' completed service calls in Stark County.
The full record by brand, appliance and town is on our repair record page.
Book online any time, or call or text (330) 915-7222.