Brand: Maytag · Appliance: Dryer · City: Navarre, OH · Model: MED6230HW2 · Serviced: September 11, 2026
The Problem
Dryer control panel completely unresponsive — no display, will not power on; drum light works but panel does not light up or function
The Repair
Dryer was found dead with F2E1/F2E2 keypad fault codes, later powering back on when checked. Investigation traced the root cause to the exhaust vent being blocked by a boat towel — left behind by the plumbing/water heater company that had disconnected and moved the washer/dryer in February to access the water heater behind them, plugging the vent through the wall with the towel and never removing it. Vent was fully cleared and towel removed. Keypad/UI panel tested good with no fault recurrence — confirms the earlier F2 codes were a byproduct of the dead/reset event rather than a failing touchpad. Also verified: airflow now unrestricted at vent termination, lint screen intact with no bypass, heating element continuity/amp draw normal, thermal fuse/high-limit continuity good, door switch functioning, drum rollers/glides quiet with no wobble, belt tracking true, moisture sensor bars clean, unit level with no vibration, and power cord/terminals in good condition with both legs of 240V present. Dryer running quiet post-repair, blower wheel (recently replaced) operating normally. Job complete — no parts needed.
What a Repair Like This Costs
A job in this range typically runs $167–$280, parts and labor included. The exact number depends on the part, the model, and how much labor the job takes. You get a flat-rate quote before any work starts, and the service call is applied toward the repair when you go ahead. See what appliance repair costs in Canton.
Appliance repair in Navarre · Maytag repair · Dryer repair
Having the same trouble?
We work on Maytag and every other major brand across Stark County. Scheduling is open 24 hours a day; service calls run Monday–Friday, 8am–5pm.
Request Service or call (330) 915-7222
Job #: 6176 · Date of service: September 11, 2026 · Status: Completed